Equipped With

14" X 40" ACRA MODEL 1440TVS PRECISION VARIABLE SPEED GAP BED ENGINE LATHE

Bed & Stand:
Base One Piece Casting
Meehanite Casting, Vibration Stress Relieved
Induction hardened And Precision Ground Bed Ways
Precision Hand Scraped Removable Gap
Foot Brake
Turcite B Coating Between The Bed And Carriage
Spindle:
Supported By 2 Precision Taper Roller Bearings And One Ball Bearing
Dynamically Balanced, Hardened, And Precision Ground
D1-6 Spindle Nose
2-1/6” Diameter Spindle Nose
Apron & Saddle:
Automatic Feed And Threading, Fully Interlocked
Saddle And Top Slide Locking System
Forward-Off-Reverse Lever
4 Way Tool Post
Universal Gear Box:
Oil Bath Lubrication
Heat Treated Precision Ground Gears
Inch, Metric, Module, And Diametrical Threads
Drive:
5 HP 4 Pole AC Inverter
UL AC Inverter
Conveniently Located Control Panel
Digital RPM Meter
20~400 RPM Low Range
400~2800 RPM High Range
Head Stock:
TVS Series-Pressurized Lubrication System
All Gears Chromium Molybdenum, Heat Treated And Precision Ground

Specifications:
Capacity:                                                     14″/21″ x 40″
Swing Over Bed:                                         14-3/16″
Swing Over Cross Slide:                              8-3/8″
Swing In Gap:                                              21″
Distance Between Centers:                         40″
Bed Width:                                                  10-1/4″
Spindle Nose:                                              D1-6
Spindle Bore:                                               2-1/16″
Taper of Spindle:                                         MT NO.6
Spindle Speeds – Steps:                              2
Spindle Speeds – Range:                            20 ~ 2500 RPM
Cross Slide Travel:                                       8-11/16″
Compound Slide Travel:                              5-1/2″
Inch Threads:                                               2 ~ 72 TPI
Metric Threads:                                           0.2 ~ 14 mm
Longitudinal Feeds:                                     0.002 ~ 0.067″/rev
Cross Feeds:                                                0.001 ~ 0.034″/rev
Tailstock:
        Quill Diameter:                                    2″
        Quill Travel:                                         6″
        Quill Taper:                                         MT NO.4
Spindle Drive Motor:                                  5 HP
Voltage:                                                      230V AC/ 1 PH/ 3 PH
Weight                                                       3640 lbs

Standard Equipment:
8″ 3-Jaw Chuck
10″ 4-Jaw Chuck
Full Length Splash Guard
Inverter Controlled Motor
Chuck Guard
Coolant System
Halogen Light
Face Plate
Steady/Follow Rest
4 Way Tool Holder
Center Sleeve
Foot Brake